Odisha Forum

HI to all,
I am writing some necessary steps ,which will help you when your induction cook-top shows the error message.
These are the standard Error Codes:It shows-

E0 - if your pot is placed incorrect, place the pan correctly

E1 - if The circuit has malfunctioned,pls check it.

E2 - if short circuit,or temperature sensor is opening circuit .pls check it.


E3 - if the voltage is higher (140V-160V)for 3 seconds,voltage should be lowered.

E4 - if the voltage is lower (80V-100V) for 3 seconds

E5 - if the cook-top surface temperature is too high,pls low down the temp.

E6 - if the internal Electronic Temperature is higher than normal for 3 seconds

E7 -if the internal Electronic Temperature sensor is open circuit or short circuit

thank you sir,
your post about induction cook-top had helped me a lot.thanks again.

Thanks for sharing this information to me.really it is very helpful to me like this i got one site for students you can visit http://allaboutedu.com/best-colleges-in-india